Audi Audi TTS 2015-present 2.0L Engine Specifications
Detailed technical specifications and service documentation for the 2.0L TFSI engine in the 2015-Present Audi TTS. Includes performance data, component details, and maintenance guidelines.
Overview Specifications
Comprehensive description of the 2.0l-engine specifications for the 2015-Present Audi TTS, including key features, measurements, and technical details
How to Use
Use the search bar to find specific 2.0l-engine specifications by entering keywords such as 'torque', 'horsepower', or 'fuel system'.
Navigate through the 2.0l-engine documentation sections using the table of contents or by scrolling through the document. Each section is clearly labeled for easy access.
Key Specifications
Engine Type
2.0L TFSI Inline-4
Horsepower
306 hp @ 6,500 rpm
Torque
295 lb-ft @ 2,000-5,200 rpm
Fuel Economy
23 mpg city / 30 mpg highway
Displacement
1,984 cc
Available Specifications
Engine Performance
Detailed information on the performance capabilities of the 2.0l-engine, including power output, torque, and acceleration.
Engine Performance
Detailed information on the performance capabilities of the 2.0l-engine, including power output, torque, and acceleration.
Power Output
- Maximum power output: 306 hp (228 kW) at 6,500 rpm
- Peak torque: 295 lb-ft (400 Nm) at 2,000-5,200 rpm
- Redline: 6,800 rpm
- Compression ratio: 9.6:1
- Turbocharger: Single twin-scroll turbocharger
Acceleration
- 0-60 mph (0-97 km/h): 4.6 seconds
- Top speed: 155 mph (250 km/h) (electronically limited)
- Quarter-mile time: 13.1 seconds
- Power-to-weight ratio: 8.2 lb/hp
Note: Performance figures may vary slightly depending on driving conditions and vehicle configuration.
Fuel System
Technical details about the fuel delivery system, including fuel type, injection system, and efficiency.
Fuel System
Technical details about the fuel delivery system, including fuel type, injection system, and efficiency.
Fuel Type and Injection
- Fuel type: Premium unleaded (91 octane or higher)
- Injection system: Direct fuel injection
- Fuel tank capacity: 14.5 gallons (55 liters)
- Fuel economy: 23 mpg city / 30 mpg highway
- CO2 emissions: 199 g/km
Efficiency Features
- Start-stop system: Standard
- Cylinder deactivation: Not available
- Thermal management system: Optimized for quick warm-up
- Regenerative braking: Not applicable
Note: Fuel economy figures are based on EPA estimates and may vary in real-world conditions.
Engine Construction
Details on the materials, design, and layout of the 2.0l-engine, including block and cylinder head construction.
Engine Construction
Details on the materials, design, and layout of the 2.0l-engine, including block and cylinder head construction.
Block and Cylinder Head
- Engine block material: Aluminum alloy
- Cylinder head material: Aluminum alloy
- Cylinder arrangement: Inline-4
- Bore x stroke: 82.5 mm x 92.8 mm
- Displacement: 1,984 cc
Valvetrain and Cooling
- Valvetrain: DOHC, 16 valves
- Camshaft drive: Timing chain
- Cooling system: Liquid-cooled
- Oil capacity: 5.7 liters (with filter)
- Oil type: Synthetic 5W-40
Note: Regular maintenance of the timing chain and cooling system is critical for long-term reliability.
Exhaust System
Information on the exhaust system design, including emissions control and sound tuning.
Exhaust System
Information on the exhaust system design, including emissions control and sound tuning.
Exhaust Design
- Exhaust configuration: Dual exhaust with quad tips
- Catalytic converter: Close-coupled for quick warm-up
- Exhaust material: Stainless steel
- Sound tuning: Active exhaust valve for sporty sound
Emissions Control
- Emissions standard: Euro 6 / Tier 3
- Particulate filter: Not equipped
- NOx reduction: Selective catalytic reduction (SCR)
- Exhaust gas recirculation (EGR): Yes
Note: The active exhaust valve can be controlled via the Audi Drive Select system.
Search Specifications
Search by specification name, value, or description
Type to search through torque specifications. Results will appear below as you type.
Engine Specifications
General
- Engine Code
- EA888 Gen 3
- Displacement
- 2.0 liters
- Configuration
- Inline-4
- Aspiration
- Turbocharged
- Fuel Type
- Premium unleaded gasoline (95 RON minimum)
- Manufacturer
- Audi AG
- Part Number
- 06K-100-000-A
Performance
- Max Power
- 310 hp @ 5300-6200 rpm
- Max Torque
- 280 lb-ft @ 1800-5200 rpm
- Compression Ratio
- 9.6:1
- Redline
- 6500 rpm
- Boost Pressure
- 18.0 psi
Dimensions
- Bore
- 82.5 mm
- Stroke
- 92.8 mm
- Cylinder Spacing
- 88 mm
- Engine Weight
- 148 kg (dry)
- Oil Capacity
- 5.7 liters
Fuel System
- injection Type
- Direct injection
- Fuel Pressure
- 200 bar
- injector Part Number
- 06K-906-036-C
- Fuel Pump Part Number
- 06E-919-051-B
Ignition System
- Spark Plug Type
- NGK PLFER7A8EG
- Spark Plug Gap
- 0.7-0.8 mm
- Ignition Coil Part Number
- 06E-905-115-E
- Ignition Timing
- Adjustable via ECU
Cooling System
- Coolant Capacity
- 7.5 liters
- Thermostat Opening Temp
- 87°C
- Radiator Part Number
- 8S0-121-251-C
- Water Pump Part Number
- 06K-121-011-D
Lubrication System
- Oil Type
- VW 502 00 / 504 00
- Oil Viscosity
- 5W-40
- Oil Filter Part Number
- 06E-115-562-C
- Oil Pump Part Number
- 06K-115-105-A
Emissions
- Emission Standard
- EU6
- Catalytic Converter Part Number
- 8S0-254-010-D
- Oxygen Sensor Part Number
- 06A-906-262-C
- EGR System
- Integrated with turbocharger
Turbocharger
- Turbo Type
- Single-scroll turbocharger
- Turbo Part Number
- 06K-145-702-G
- Wastegate Actuator Part Number
- 06K-145-710-A
- Boost Control
- Electronic wastegate
Maintenance
- Spark Plug Replacement interval
- 60,000 miles
- Timing Chain Replacement Interval
- Lifetime (inspect at 100,000 miles)
- Oil Change interval
- 10,000 miles or 12 months
- Coolant Flush interval
- 5 years or 50,000 miles
- Air Filter Replacement interval
- 40,000 miles
Diagnostics
- OBD2 Port Location
- Under dashboard, driver's side
- Common Fault Codes
-
- P0300
- P0171
- P0299
- Diagnostic Tool
- VCDS (VAG-COM Diagnostic System)
- Sensor References
- Crankshaft Position Sensor: 06K-907-321-BCamshaft Position Sensor: 06K-907-322-A
Service Information Service
Detailed service requirements and schedules for the 2.0L TFSI engine in the Audi TTS
- Oil and filter change
- Inspect brake system
- Check tire pressure and condition
Use only VW 502 00 / 504 00 certified oil
- Replace air filter
- Inspect spark plugs
- Check timing chain tension
Replace spark plugs if necessary
- Replace spark plugs
- Inspect turbocharger system
- Check coolant concentration
Perform coolant flush if concentration is below specification
- Inspect timing chain and guides
- Replace coolant
- Check fuel injectors
Replace timing chain components if wear is detected
Common Questions
Find answers to common questions about torque specifications
Q1 What is the horsepower and torque output of the 2.0L TFSI engine in the 2015-Present Audi TTS?
What is the horsepower and torque output of the 2.0L TFSI engine in the 2015-Present Audi TTS?
The 2.0L TFSI engine in the Audi TTS produces 292 horsepower at 5,400-6,400 RPM and 280 lb-ft of torque at 1,900-5,300 RPM. This engine features turbocharging and direct fuel injection for optimal performance.
Q2 What type of fuel is recommended for the 2.0L TFSI engine in the Audi TTS?
What type of fuel is recommended for the 2.0L TFSI engine in the Audi TTS?
Audi recommends using premium unleaded gasoline with an octane rating of 91 or higher for the 2.0L TFSI engine. Using lower-octane fuel may result in reduced performance and efficiency.
Q3 What is the oil capacity and recommended oil type for the 2.0L TFSI engine?
What is the oil capacity and recommended oil type for the 2.0L TFSI engine?
The 2.0L TFSI engine requires approximately 5.7 liters (6 quarts) of oil. Audi recommends using VW 502 00 or VW 504 00 certified synthetic oil with a viscosity of 5W-40 or 5W-30, depending on operating conditions.
Q4 What is the service interval for the 2.0L TFSI engine in the Audi TTS?
What is the service interval for the 2.0L TFSI engine in the Audi TTS?
Audi recommends an oil change and inspection service every 10,000 miles or 12 months, whichever comes first. Additional maintenance tasks, such as spark plug replacement, are required every 40,000 miles.
Q5 Does the 2.0L TFSI engine require a specific coolant type?
Does the 2.0L TFSI engine require a specific coolant type?
Yes, the 2.0L TFSI engine requires Audi-approved G12 or G13 coolant. Mixing incompatible coolants can lead to engine damage and void the warranty.
Q6 What is the compression ratio of the 2.0L TFSI engine?
What is the compression ratio of the 2.0L TFSI engine?
The 2.0L TFSI engine has a compression ratio of 9.6:1, which is optimized for turbocharged performance and efficiency.
Factory Service Resources
Access official service manuals, technical documents, and repair guides. These resources provide detailed procedures, specifications, and diagrams directly from the manufacturer.
Audi TTS 2.0L TFSI Engine Technical Specifications
Coming SoonDetailed technical specifications for the 2.0L TFSI engine, including performance metrics, dimensions, and component details.
Audi TTS Maintenance Schedule
Coming SoonComprehensive maintenance schedule for the Audi TTS, including service intervals and recommended procedures for the 2.0L TFSI engine.
Audi Genuine Parts Catalog
Coming SoonAccess the official Audi parts catalog to find genuine components for the 2.0L TFSI engine, ensuring optimal performance and warranty compliance.
Audi TTS Owner's Manual
Coming SoonDownload the official owner's manual for the Audi TTS, which includes detailed information on the 2.0L TFSI engine and its operation.
Legal Disclaimer
Important information about using this content
Always refer to your vehicle's service manual and take appropriate safety precautions when performing any maintenance or repairs.
General Information
Warranty & Liability
The content on this website is provided "as is" without any representations or warranties, express or implied. We make no representations or warranties regarding the accuracy, completeness, or availability of the information.
We shall not be liable for any direct, indirect, special, or consequential damages arising from the use of information on this website.
Technical Information
- All specifications, including torque values, fluid capacities, and maintenance procedures, should be verified against your vehicle's factory service manual.
- Vehicle specifications and procedures may vary by model year, trim level, and region.
- Always follow the manufacturer's recommended procedures and safety precautions.
- Working on vehicles can be dangerous. Always take proper safety precautions and use appropriate safety equipment.
- If you're unsure about any procedure, consult a qualified professional mechanic.
Intellectual Property
About the Author
Expert automotive knowledge and experience
Diagnostic
Specialized in advanced diagnostic techniques using modern scan tools and oscilloscopes.
Repair
Expert in both traditional mechanical repairs and modern vehicle systems.
Additional Expertise
Documentation
Created over 500 detailed repair guides and technical documents.
Training
Conducted technical training sessions and contributed to repair databases.
Certifications & Research
Certifications
- ASE Master Technician Certification
- Advanced Diagnostic Specialist
- Hybrid/Electric Vehicle Systems
- Performance Tuning Expert
Research & Community
Actively researches emerging technologies and contributes to automotive forums.