Audi Audi RS5 2010-2016

Audi Audi RS5 2010-2016 Electrical Specifications

Detailed technical specifications for the electrical system of the 2010-2016 Audi RS5, including wiring diagrams, fuse layouts, and control module details.

Updated Oct 24, 2023

Overview Specifications

Comprehensive description of the electrical specifications for the 2010-2016 Audi RS5, including key features, measurements, and technical details. This section provides detailed insights into the vehicle's electrical systems, including wiring, battery, alternator, and control modules.

How to Use

Use the search function to locate specific electrical specifications by entering keywords such as 'battery capacity', 'alternator output', or 'fuse ratings'.

Navigate through the electrical documentation sections using the table of contents or by scrolling through the major sections listed below.

Key Specifications

Battery Capacity

70 Ah

Alternator Output

180 A

Main Fuse Rating

150 A

Headlight Power

35 W

Infotainment Power

150 W

Available Specifications

Battery and Charging System

This section covers the battery specifications, alternator output, and charging system details for the Audi RS5.

Battery Specifications

Battery type: AGM (Absorbent Glass Mat)
Battery capacity: 70 Ah
Cold cranking amps (CCA): 760 A
Voltage: 12 V
Battery weight: 22.5 kg

Alternator Specifications

Alternator type: Bosch 180 A
Output voltage: 14.4 V
Maximum output current: 180 A
Efficiency: 85%
Weight: 6.8 kg

Note: The alternator is designed to support high electrical loads, including advanced infotainment and lighting systems.

Wiring and Fuse System

This section provides details on the wiring harness, fuse ratings, and circuit protection mechanisms.

Wiring Harness

Total length of wiring: ~2.5 km
Wire gauge range: 0.5 mm² to 25 mm²
Insulation material: Cross-linked polyethylene (XLPE)
Color coding: Standardized for easy identification

Fuse Ratings

Main fuse rating: 150 A
Fuse types: Mini, ATO, and Maxi
Fuse box locations: Engine bay and interior
Circuit protection: Thermal and overcurrent

Note: Fuse ratings are critical for protecting sensitive electronic components.

Control Modules and Sensors

This section details the electronic control units (ECUs) and sensors used in the Audi RS5.

Engine Control Module (ECM)

Processor: 32-bit microcontroller
Operating voltage: 5 V
Communication protocol: CAN bus
Memory: 2 MB flash, 128 KB RAM

Sensors

Oxygen sensor: Wideband lambda sensor
Temperature sensor range: -40°C to 150°C
Pressure sensor range: 0 to 5 bar
Speed sensor: Hall effect type

Note: Sensors are critical for real-time monitoring and feedback to the ECUs.

Lighting and Infotainment

This section covers the electrical specifications for the lighting and infotainment systems.

Lighting System

Headlight type: Bi-xenon with LED daytime running lights
Headlight power consumption: 35 W per bulb
Taillight type: Full LED
Interior lighting: LED ambient lighting

Infotainment System

Display size: 7-inch MMI touchscreen
Audio output: 14-speaker Bang & Olufsen system
Power consumption: 150 W
Connectivity: Bluetooth, USB, and SD card

Note: The infotainment system is integrated with the vehicle's CAN bus for seamless operation.

Search Specifications

Search by specification name, value, or description

Component Specifications

Battery

Type: AGM (Absorbent Glass Mat)

Capacity: 70 Ah

Cold Cranking Amps: 760 A

Voltage: 12 V

Part Number: 000915105DL

Maintenance: Maintenance-free

Replacement interval: 5 years or 60,000 miles

Alternator

Type: Bosch

Output: 180 A

Voltage: 14 V

Part Number: 06E903023F

Operating Temperature Range: -40°C to 120°C

Efficiency: 85%

Starter Motor

Type: Bosch

Power: 1.4 kW

Voltage: 12 V

Part Number: 06E911024E

Operating Temperature Range: -40°C to 120°C

Cranking Speed: 100-120 rpm

Fuse Box

Location: Driver's side dashboard

Fuse Types

Mini
Standard
Maxi

Fuse Ratings

Part Number: 8K0941153A

Maintenance: Check every 12 months or 10,000 miles

Wiring Harness

Material: Copper with PVC insulation

Wire Gauge Range: 0.5 mm² to 6.0 mm²

Temperature Rating: -40°C to 105°C

Part Number: 8K0971333A

Maintenance: Inspect for wear and corrosion every 20,000 miles

Lighting System

Headlights: Type: Xenon HID
Wattage: 35 W
Color Temperature: 4300K
Part Number: 4H0941029A

Taillights: Type: LED
Wattage: 10 W
Part Number: 8T0945097A

Fog Lights: Type: Halogen
Wattage: 55 W
Part Number: 8K0941699A

Sensors

Oxygen Sensor: Type: Wideband
Voltage Range: 0.1 V to 0.9 V
Part Number: 06E906262B
Operating Temperature: -40°C to 800°C

Crankshaft Position Sensor: Type: Hall Effect
Voltage: 5 V
Part Number: 06E907405C
Operating Temperature: -40°C to 150°C

Camshaft Position Sensor: Type: Inductive
Voltage: 12 V
Part Number: 06E907404A
Operating Temperature: -40°C to 150°C

Control Modules

Engine Control Module: Type: Bosch MED17.1
Voltage: 12 V
Part Number: 8K0907115B
Operating Temperature: -40°C to 85°C

Transmission Control Module: Type: Bosch
Voltage: 12 V
Part Number: 8K0927156D
Operating Temperature: -40°C to 85°C

Body Control Module: Type: Bosch
Voltage: 12 V
Part Number: 8K0907069C
Operating Temperature: -40°C to 85°C

Charging System

Charging Voltage: 13.5 V to 14.5 V

Charging Current: 180 A

Battery Management System: Integrated

Part Number: 8K0907551A

Maintenance: Inspect every 20,000 miles

Diagnostic System

Diagnostic Port: Type: OBD-II
Location: Under dashboard, driver's side
Protocols: ISO 15765-4 (CAN), ISO 14230-4 (KWP2000)

Diagnostic Tools

VCDS (VAG-COM)
ODIS (Offboard Diagnostic Information System)

Error Codes

P0001-P2999
U0001-U2999
B0001-B2999

Maintenance: Check for error codes every 10,000 miles

Service Information Service

Detailed service requirements and schedules

10,000 miles

12 months

Check battery voltage and connections
Inspect alternator and starter motor
Check fuse box for blown fuses

Ensure all electrical connections are secure and free of corrosion

20,000 miles

24 months

Inspect wiring harness for wear and corrosion
Check lighting system functionality
Test sensors and control modules

Replace any faulty sensors or control modules as needed

60,000 miles

60 months

Replace battery if necessary
Inspect and clean alternator and starter motor
Check diagnostic system for error codes

Perform a full diagnostic scan to identify any potential issues

Frequently Asked Questions

Find answers to common questions about torque specifications

What is the voltage of the battery in the 2010-2016 Audi RS5?

The 2010-2016 Audi RS5 is equipped with a 12-volt lead-acid battery. The exact specifications are 12V, 70Ah, and 680A (EN). Ensure the battery is properly maintained and replaced with a genuine Audi part to avoid electrical system issues.

What is the alternator output for the Audi RS5?

The alternator in the 2010-2016 Audi RS5 has an output of 180A at 14V. This ensures sufficient power for the vehicle's electrical systems, including advanced features like the MMI (Multi Media Interface) and adaptive lighting.

How do I reset the electrical system after replacing the battery?

After replacing the battery, the electrical system must be reset using a diagnostic tool such as VCDS (VAG-COM Diagnostic System) or Audi's official diagnostic software. This ensures proper communication between the battery control module and the vehicle's ECU. Failure to reset may result in improper charging or electrical faults.

What is the fuse rating for the Audi RS5's headlight system?

The fuse rating for the headlight system in the 2010-2016 Audi RS5 is 15A. This protects the xenon or LED headlights, depending on the trim and options. Always replace fuses with the same rating to avoid electrical damage.

Can I install aftermarket electrical components without voiding the warranty?

Installing aftermarket electrical components may void your warranty if they cause damage to the vehicle's electrical system. Audi recommends using genuine parts and accessories to maintain warranty coverage and ensure compatibility with the vehicle's systems.

Factory Service Resources

Access official service manuals, technical documents, and repair guides. These resources provide detailed procedures, specifications, and diagrams directly from the manufacturer.

Audi RS5 Electrical System Overview

Coming Soon

Detailed guide covering the electrical system architecture, including wiring diagrams, component locations, and troubleshooting tips.

Battery Replacement and Maintenance Guide

Coming Soon

Step-by-step instructions for replacing and maintaining the 12V battery, including resetting the battery control module.

Alternator Testing and Diagnostics

Coming Soon

Technical guide on testing the alternator's output and diagnosing common electrical issues related to charging systems.

Fuse Box Layout and Specifications

Coming Soon

Comprehensive fuse box layout for the 2010-2016 Audi RS5, including fuse ratings and their corresponding electrical components.

About the Author

Expert automotive knowledge and experience

ASE

Alan Montanye

Automotive Technical Specialist

ASE Master Certified Technician with over a decade of hands-on experience in automotive repair and diagnostics.

Facebook Contact

15+ Years

Experience

500+ Guides

Guides

50+ Makes

Vehicles

1000+ Solutions

Solutions

Diagnostic

Specialized in advanced diagnostic techniques using modern scan tools and oscilloscopes.

Repair

Expert in both traditional mechanical repairs and modern vehicle systems.

Additional Expertise

Documentation

Created over 500 detailed repair guides and technical documents.

Training

Conducted technical training sessions and contributed to repair databases.

Certifications & Research

Certifications

ASE Master Technician Certification
Advanced Diagnostic Specialist
Hybrid/Electric Vehicle Systems
Performance Tuning Expert

Research & Community

Actively researches emerging technologies and contributes to automotive forums.

Legal Disclaimer

Important information about using this content

Always refer to your vehicle's service manual and take appropriate safety precautions when performing any maintenance or repairs.

General Information

The information provided on this website is for general informational purposes only. While we strive to maintain accuracy in our content, all specifications, procedures, and technical information should be verified against your vehicle's official service manual or with the manufacturer directly.

Warranty & Liability

The content on this website is provided "as is" without any representations or warranties, express or implied. We make no representations or warranties regarding the accuracy, completeness, or availability of the information.

We shall not be liable for any direct, indirect, special, or consequential damages arising from the use of information on this website.

Technical Information

All specifications, including torque values, fluid capacities, and maintenance procedures, should be verified against your vehicle's factory service manual.
Vehicle specifications and procedures may vary by model year, trim level, and region.
Always follow the manufacturer's recommended procedures and safety precautions.
Working on vehicles can be dangerous. Always take proper safety precautions and use appropriate safety equipment.
If you're unsure about any procedure, consult a qualified professional mechanic.

Intellectual Property

All content, including text, images, and specifications, is protected by copyright and other intellectual property laws. Any unauthorized use or reproduction is prohibited.